Radar measurement on plastic disc targets

Operation guide:

1. Cover the full disc surface with intact aluminum foil, no gaps or wrinkles.

2. Add a waterproof film for long-term outdoor use to prevent aluminum foil oxidation and signal attenuation.

For long-term open-air deployment or oversized targets: Use 0.1–0.3 mm thin aluminum sheets directly.

Related reading

• Installation, Wiring & 4-20mA / RS485 Setup Guide
• Can the ±2.75° beam angle be reduced? Minimum distance from silo wall for installation?
• Can the radar be used directly after installation?
• Extending power supply cables
• How do I configure the values corresponding to the 4-20 mA output?
• How do I solve an error in the 4-20 mA current output?
• Can multiple RS485 radars be wired in parallel? Can the upper computer read all units simultaneously?
• No response when reading radar data via USB-to-serial adapter and upper computer software
• What is the millimeter-wave operating frequency, modulation scheme, and supported communication protocols?

• Previous：Measurement performance with heavy foam and floating debris
• Next：No response when reading radar data via USB-to-serial adapter and upper computer software