Product FAQ

You are here : Home > Product FAQ > How to output raw ADC data on the upper computer

How to output raw ADC data on the upper computer

Q: How to output raw ADC data on the upper computer

Send AT command? AT+OUTRAWDATA=2? via upper computer; confirm reply "OK", then close the serial port. Open the Spectrum Viewer software, select the correct serial port, open the port, and click FFT Spectrum to view raw ADC waveforms. Related reading 80GHz Radar Level Sensor Troubleshooting Guide: Echo & Signal Diagnosis Information extractable from echo spectrum and corresponding fixes Measurement performance with heavy foam and floating debris Measurement shows within blind zone

Time:2026-08-07 Browse: 112

Send AT command AT+OUTRAWDATA=2 via upper computer; confirm reply “OK”, then close the serial port.
Open the Spectrum Viewer software, select the correct serial port, open the port, and click FFT Spectrum to view raw ADC waveforms.

About

Contact Us

Address: Room 301, Comprehensive Building, Coship Electronics Longgang Campus, No. 1 Baolong 5th Road, Baolong Community, Baolong Subdistrict, Longgang District, Shenzhen, Guangdong Province, P.R. China
Tel:+86 400 189 9309

Phone:+86 18124514293
E-mail:[email protected]